  |
|
FLIC Installation & Set Up
For Electric Light Strings:
1. Remove the luminaries from the reusable shipping/storage
carton. To un-stack or "de-nest" the luminaries it is easiest
to set them on a flat surface, clamp the bottom luminary between your
feet and gently pull up on the top luminary.
2. Attach the light string to each luminary.
- Remove the light string from the box and straighten
out the cord.
- Unscrew the first light bulb and remove it from its
socket. Hold the socket underneath a luminary so that the socket is
aligned with the bulb hole in the luminary. Put the light bulb base
through the bulb hole and then screw the bulb into the socket.
- Repeat for each luminary.
- When setting out the luminaries run the wire in the
wire channel under each luminary. Note: duct taping the wire into the
wire channel with two small pieces of duct tape will make placement
of the luminary easier on flat surfaces such a sidewalks, etc.
3. Hold Down Method:
- Sand, gravel, or kitty litter - use 1 1/2 cups or up
to the level of the candle base.
- Stakes - use one or two per luminary.
4. Place the luminaries in the desired location.
5. Plug the luminary light string into an electrical outlet and
turn on the luminaries..
6. Clean Up & Storage:
- You may leave lights and hold down material in FLIC Luminaries for next use. The luminaries will stack or "nest" with the light string attached.
Electric Luminary safety precautions:
1. Read and follow all safety instructions, all use and care instructions,
and all user servicing instructions that are included with the light string.
2. Luminaries should not be left unattended.
For Candles
1. Remove the luminaries from the reusable shipping/storage carton. To un-stack or "de-nest" the luminaries it is easiest to set them on a flat surface, clamp the bottom luminary between your feet and gently pull up on the top luminary.
2. Hold Down Method:
- Water - use 1 1/2 cups or up to the level of the candle
base.
- Gravel, sand or kitty litter - use 1 1/2 cups or up
to the level of the candle base.
- Stakes - use one or two per luminary.
4. Rinse inside of candle holder with water before inserting candle. This will keep wax from sticking to candle holder.
5. Place a candle holder and a candle in each luminary within the circular ring on the candle pedestal.
6. Light the luminaries.
7. Clean up:
- Properly dispose of the used candles & save the
candle holders for reuse.
- Empty the luminaries of water if water is used as hold
down material.
- Note:You may leave hold down material in FLIC Luminaries for next use. The luminaries will stack or nest.
- The original shipping carton is designed to store
the luminaries until the next use.
Candle Luminary safety precautions:
1. Luminaries should only be burned outside on a level surface.
2. Luminaries should not be placed on any flammable surface.
3. Luminaries should not be placed near anything that is flammable.
4. Luminaries should not be left unattended.
5. Don't attempt to remove candle or candle holder if molten wax is present.
Helpful Hint:
To clean Candle Holders, chill holders in freezer for a few hours. The wax will shrink and pop right out.