FLIC Installation & Set Up

For Electric Light Strings:

1. Remove the luminaries from the reusable shipping/storage carton. To un-stack or "de-nest" the luminaries it is easiest to set them on a flat surface, clamp the bottom luminary between your feet and gently pull up on the top luminary.

2. Attach the light string to each luminary.

• Remove the light string from the box and straighten out the cord.
  
  
• Unscrew the first light bulb and remove it from its socket. Hold the socket underneath a luminary so that the socket is aligned with the bulb hole in the luminary. Put the light bulb base through the bulb hole and then screw the bulb into the socket.
  
  
• Repeat for each luminary.
  
  
• When setting out the luminaries run the wire in the wire channel under each luminary. Note: duct taping the wire into the wire channel with two small pieces of duct tape will make placement of the luminary easier on flat surfaces such a sidewalks, etc.
  

3. Hold Down Method:

• Sand, gravel, or kitty litter - use 1 1/2 cups or up to the level of the candle base.
  
  
• Stakes - use one or two per luminary.
  

4. Place the luminaries in the desired location.

5. Plug the luminary light string into an electrical outlet and turn on the luminaries..

6. Clean Up & Storage:

• You may leave lights and hold down material in FLIC Luminaries for next use. The luminaries will stack or "nest" with the light string attached.

Electric Luminary safety precautions:

1. Read and follow all safety instructions, all use and care instructions, and all user servicing instructions that are included with the light string.

2. Luminaries should not be left unattended.

For Candles

1. Remove the luminaries from the reusable shipping/storage carton. To un-stack or "de-nest" the luminaries it is easiest to set them on a flat surface, clamp the bottom luminary lengthwise between your feet and gently pull up on the top luminary.

2. Hold Down Method:

• Water - use 1 1/2 cups or up to the level of the candle base.
  
  
• Gravel, sand or kitty litter - use 1 1/2 cups or up to the level of the candle base.
  
  
• Stakes - use one or two per luminary.
  

4. Rinse inside of candle holder with water before inserting candle. This will keep wax from sticking to candle holder.

5. Place a candle holder and a candle in each luminary within the circular ring on the candle pedestal.

6. Light the luminaries at the desired time.

7. Clean up:

• Properly dispose of the used candles & save the candle holders for reuse. Candle holders can be reused up to 5 times.
  
  
• Empty the luminaries of water if water is used as hold down material.
  
  
• Note:You may leave hold down material in FLIC Luminaries for next use. The luminaries will stack or nest.

• The original shipping carton is designed to store the luminaries until the next use.

2. Luminaries should not be placed on any flammable surface.

3. Luminaries should not be placed near anything that is flammable.

4. Luminaries should not be left unattended.

5. Don't attempt to remove candle or candle holder if molten wax is present.